Service Manual
5. Needle threader height --continued--
Hook
7. If the direction of insert hook is deviated from correct position, adjust the hook
position with the small screw driver in the accessory.
Needle hole
8. If hook protrudes from needle hole too much or little, it may affect threading
condition. Loosen nut (F) under threader support shaft and turn hook portion
(G) in either way for adjustment. Tighten the nut (F) securely after adjustment.
F
90/14
80/11
Hook
G
70/9
Insert the hook into the
upper side of needle hole.
F
Original issue
Dec.2007
Page 15/47
Model
COSMO-II series
G