Table of Contents
Advertisement
INSTALLING AND POINTING YOUR SATELLITE DISH
Assembling the HANT-3_ or HANT-4_ Antenna
If you have antenna model HANT-4_, proceed to step 4.
1) Insert a flat-head screw into one of the holes in the face of the reflector, as shown.
2) For the model HANT-3_ antenna only, install a spacer onto the screw. The spacer fits tightly,
Assembling the HANT-3_S Antenna
1) Insert a flat-head screw into one of the holes in the face of the reflector, as shown.
so you may have to twist it into place. Install the spacer so
the concave side is against the reflector surface.
3) Repeat steps 1 and 2 to install the remaining three
sets of flat-head screws and spacers.
4) Install the mounting bracket of the LNB support arm
onto the four flat-head screws, as shown.
5) Loosely install a flat washer, lock washer, and ¼-inch
nut onto the portion of each flat-head screw that sticks
through the back of the reflector, spacer, and mounting
bracket.
6) Tighten the four ¼-inch nuts. The heads of the flat-
head screws must be flush on the inside surface of the
reflector to be securely fastened to the LNB support arm.
With the arm securely attached to the reflector, you
should proceed to the section titled "Installing the
Antenna Assembly onto the Mast or Pole."
2) Install the mounting bracket of the LNB support
arm onto the four flat-head screws, as shown.
3) Loosely install a ¼-inch nut onto the portion of
each flat-head screw that sticks through the back of the
reflector and mounting bracket.
4) Tighten the four ¼-inch nuts. The heads of the
flat-head screws must be flush on the inside surface of
the reflector to be securely fastened to the LNB
support arm.
5) Install the cable clip as shown.
P
4-13
AGE
Advertisement
Table of Contents
