Assembly And Set-Up - Razor vector Owner's Manual

ASSEMBLY AND SET-UP

Attaching the Handlebar
Required Tool: 5 mm Allen Wrench (included)
1
Using a 5 mm Allen wrench, loosen the bolts from the
collar clamp.
3
With the front wheel pointed straight ahead and the handlebars square to the front wheel, tighten both bolts on
the clamp using a 5 mm Allen wrench. Tighten securely.
Attaching the Seat
1
Open the quick-release lever.
Note: The tension of the quick-release lever can be
adjusted by manually tightening or loosening the Allen
bolt. Be careful not to over-tighten. You should always
be able to open and close the quick-release lever by hand
and the seat should slide freely when the quick-release
is open.
2
With a twisting motion, push and twist to slide the
handlebars onto the fork.
2
Insert the seat post. Adjust the seat to the desired
height and close the quick-release lever to lock in place.
Note: The assembly and adjustment should not pass the
vertical safety lines (A).
4 4
A