Before You Begin - Razor vector Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents that may have occurred during shipping. Because
your scooter was partially assembled and packed at the factory, there should not be any problems, even if the box
has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 15 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 5 for charging information).
Throttle
Handlebar
Collar Clamp
Front Fork
Pneumatic Tire
Required Tools
5 mm Allen Wrench
(Included)
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
Brake Lever
1.
Footpegs
Charger
(Note: Charger design may
vary from one shown)
2.
Seat
Quick-Release Lever
2.
Pneumatic Tire
Charger Port
Kickstand
3 3
WARNING:
DO NOT USE NON-RAZOR PARTS
WITH YOUR RAZOR ELECTRIC
SCOOTER. Razor scooters have
been built to certain Razor design
specifications. The original
equipment supplied at the time
of sale was selected on the basis
of its compatibility with the
frame and all other parts. Certain
aftermarket components may not
be compatible. Use of non-Razor
parts will void the warranty.
Product ID Locations:
(See locations to the left)
1. Handlebar
2. Back of Seat Post
3. Charger
4. UPC Side of Box (Not Shown)
Hub Motor
Box Contents:
• Vector
• Charger
• Owner's Manual
• Allen Wrench