Switching The Power On And Off; Switching On The Controller; Switching Off The Controller - Roland HU-600 User Manual

2-1 Switching the Power On and Off

When not in use for extended periods, unplug the power-cord plug from the electrical outlet.
Switching On the Power
1 Switch on the sub power for the printer.
2 Switch on the [POWER] switch for the heater.
After the display flashes for a short time, both [SV] and
[PV] light up and indicate their values.
The [C1] indicator on the display lights up.
3
The heater starts operating.
When the display shows characters other than numerical figures, such as UUUU or LLLL, immediately switch off the heater
and contact your authorized Roland DG Corp. dealer or service center.
Switching Off the Power
Switch off the [POWER] switch for the heater.
1
Switch off the sub power for the printer.
2
When switching off the power for the printer, be sure to switch off the heater as well.
Switching off the printer doe not switch off the power for the heater. Never leave only the heater switched on and powered.
The preset temperature of the heater is saved in memory when the controller is switched off.
16 2. Using the Heater Unit