Ashley AF1500E Owner's Operation And Instruction Manual page 11

STEP 7
Reattach the cover using the previously removed (4)
four #10 X 1/2 screws.
STEP 8
Insert the wire into the cable clamp make a loop as
shown and then route the wire back through the cable
clamp.
STEP 9
Connect the wire to the servo arm by looping the wire
around the 1/4-20 X 3/4 bolt as shown. After the wire
loop is in position reduce the loop size so that it is smaller
than the washer. This will prevent it from sliding off once
the unit is in operation. Tighten down the two screws so
the wire is not able to move.
STEP 10
Attach the non-adjustable limit switch and adjustable
thermodisc to the back of the unit as shown using
(3) three #10 X 1/2 screws. NOTE: The non-adjustable
limit switch must be installed above the adjustable
thermodisc.
STEP 11
Route the two red wires included with this kit through
the existing conduit that runs from the junction box up
to the T'stat bracket assembly box.
STEP 12
Attach the female terminals to both ends of the red
wires.
STEP 13
Connect the conduit
"Thermostatically Controlled Damper Wiring Diagram"
for proper wiring installation). Reattach the T'stat
bracket assembly to the back of the unit using (4) four
#10 X 1/2 screws.
-11-
to the thermodisc (see