Battery Replacement - Tripp Lite SmartPro SMART2200RM2U Owner's Manual

Battery Replacement

Under normal conditions, the original batteries in your UPS will last many years. See Safety section
before replacing batteries. The batteries are designed for hot-swap replacement (i.e. leaving the
UPS in ON mode), but some qualified service personnel may wish to put the UPS in the OFF mode
and disconnect equipment before proceeding. Note: Refer to the label on the battery retention
plate for the R.B.C. part number.
RBC58-2U Battery Replacement Procedure (Applies to
SMART3000RM2UP, SMART3000RMXL2U and SMART3000RMXLN
Models)
1
Remove Front Panel
1
4 x screws
2
Remove Battery Retention Plate
4 x screws
2
3
Disconnect Batteries
3
4
Remove/Recycle Batteries
First, remove the left row of batteries.
4A
Then, slide the right row of batteries to
4B
the left and remove.
4A
4B
18