Connections; Connecting The Audio Components - Denon DRA-685 Operating Instructions Manual

ENGLISH

5 CONNECTIONS

• Do not plug in the power cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left
with left, right with right).
• Insert the plugs securely. Incomplete connections will result in
the generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not use
them for hair driers, etc.

Connecting the audio components

Turntable (MM cartridge)
NOTE:
This unit cannot be used
with MC cartridges
directly. Use a separate
head amplifier or step-
up transformer.
Ground wire
LINE OUT
LINE IN
Tape deck
R L R L
R L R L
OUTPUT INPUT
Connecting a tape deck
Connections for recording:
Connect the tape deck's recording input jacks
(LINE IN or REC) to this unit's tape recording
(OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck's playback output jacks
(LINE OUT or PB) to this unit's tape playback
(IN) jacks using pin plug cords.
6
OUTPUT
R
R
R L
PHONO
SIGNAL R L IN
VIDEO
GND
OUT
LOOP
ANT. CD MONITOR
AM
L
DVD /
DVD /
VDP VDP
R
V.AUX V.AUX
IN
FM
COAX.
VCR
VCR
75
L
MULTI
TAPE
SOURCE
ANTENNA
R
OUT
MULTI
OUT
SOURCE VCR VCR
IN
TAPE
R L R L OUT ROOM TO ROOM
R L R L
(REMOTE CONTROL)
AUDIO
LINE IN
• Note that binding pin plug cords together with power cords or
placing them near a power transformer will result in generating
hum or other noise.
• If hum or other noise is produced when the ground wire is
connected, disconnect it.
• Noise or humming may be generated if a connected
component is used independently without turning the power of
this unit on. If this happens, turn on the power of the this unit.
CD player
L
DIGITAL AUDIO DIGITAL AUDIO
L
PRE OUT jacks
MAIN IN jacks
Use these jacks when using
another separate amplifier or a
pre-main amplifier.
AUDIO
R L
PRE OUT
MAIN IN
AUX OUT
Sub room
RC-617 (Sold Separately)
Infrared sensor
+
OUTPUT INPUT
Power amplifier
AC OUTLETS
• SWITCHED
(total capacity – 120 W (1 A.)
The power to this outlet is turned on and off in conjunction with the POWER
operation switch on the main unit, and when the power is switched between
on and standby from the remote control unit.
No power is supplied from these outlets when this unit's power is at standby.
Never connect equipment whose total capacity is above 120 W (1 A.)
NOTE:
Use the AC OUTLETS for audio equipment only. Do not use them for hair
driers, etc.
Connecting a CD player
Connect the CD player's analog output jacks (ANALOG
OUTPUT) to this unit's CD jacks using pin plug cords.
AC CORD
AC 120 V, 60 Hz
SPEAKER SYSTEMS AC OUTLETS
B A
R L R L SWITCHED
TOTAL 120W(1A.) MAX.
120V 60Hz
+ +
- -
A + B : 8 16
IMPEDANCE A or B : 4 16
RC-616 (Sold Separately)
Infrared retransmitter
+
Connecting the AC OUTLETS