Status Button - Denon DRA-685 Operating Instructions Manual

Front panel display
When an operation is performed on the remote control unit, that operation appears on the display, making it possible to check the operation
visually.
The set's operating status can also be checked on the display using the procedure described below.
6
SP-A
SET UP
SELECT
VIDEO SELECT
RETURN
CHANNEL
B
REMOTE CONTROL UNIT RC-872
Recording the program source
(recording the source currently being monitored)
1
Follow steps 1 to 3 under "Playing the program source".
Simultaneous recording
The signals of the source selected with the function selector button are output simultaneously to the TAPE and VCR REC OUT jacks. If a
total of two tape and/or video decks are connected and set to the recording mode, the same source can be recorded simultaneously on
every decks.
In addition, if the TAPE MONITOR button is pressed, the audio signals from the tape deck are output to the VCR AUDIO REC OUT jacks.
Tape monitor function
2
When a three-head tape deck is used, the sound actually being recorded can be monitored during recording by pressing the TAPE MONITOR
button.
Press the button again to cancel monitoring.
2
7
SP-B
MENU
VOLUME
STATUS MUTING
1
DISPLAY
TV VOLUME
1 Press the STATUS button.
STATUS
DISPLAY
• The input and output sources and the setting, etc., appear in
order on the display each time the button is pressed.
2
Start recording on the tape or video deck.
For instructions, refer to the component's operating
instructions.
ENGLISH
Set the slide switch to "AUDIO".
23