Check Power Cord; Power Cord Requirements - Intel SRPL8 Quick Start Manual

Check Power Cord

WARNING
Do not modify or use a supplied AC power cord if it is not the exact type
required in the region where the server will be installed and used.
Replace the cord with the correct type. Refer to the cord requirements
described below.
Do not plug in the server power cord yet if you will be adding internal
parts (boards, DIMMs, removable media drives). (For these installation
procedures, see the Product Guide.)

Power Cord Requirements

•
Rating: Cords must be rated for available AC voltage and have a current rating at least 125%
of current rating of server.
•
Connector, wall outlet end: Cords must be terminated in grounding-type male plug designed
for use in your region. It must have certification marks showing certification by an agency
acceptable in your region.
•
Connector, server end: The connector that plugs into the AC receptacle on the server must
be an IEC 320, sheet C19, type female connector.
B
C
A
D
B
Figure 8. Installing the Server in the Rack
A. Small outer bar
B. Center bar
C. Large outer bar
D. Safety latch
OM11073
SRPL8 Server System 13