Table of Contents
Advertisement
Troubleshooting
Check
Has condensation formed on the lens?
Interference or distortion appear in images
Check
Are the cables connected correctly?
Is an extension cable being used?
(Only when projecting computer image sig-
nals)
Is the correct resolution selected?
Part of the image is truncated (large) or small
Check
Is the correct Aspect selected?
(Only when projecting computer image sig-
nals)
Is the correct resolution selected?
Image colors are not right
Check
Are the cables connected correctly?
Is the contrast adjusted correctly?
Is the color adjusted correctly?
(Only when projecting images from a video
device)
Are the color saturation and tint adjusted cor-
rectly?
If the projector is suddenly taken from a cold environment to a
warm environment, or if sudden ambient temperature changes
occur, condensation may form on the surface of the lens, and this
may cause the images to appear fuzzy. Set the projector up in
the room about one hour before it is used. If the projector is wet
from condensation, turn off the projector, disconnect the power
cord, and leave it for a while.
Check that all the cables required for projection are securely
connected.
p.18
s
If an extension cable is used, electrical interference may affect
the signals.
Set the computer so that the signals being output are compatible
with the projector.
p.77
s
Select the aspect mode to match the input signal in Aspect from
the Configuration menu.
Set the computer so that the signals being output are compatible
with the projector.
p.77
s
Check that all the cables required for projection are securely
connected.
p.18
s
Adjust the Contrast setting from the Configuration menu.
Image - Contrast
p.51
s
Adjust the Advanced setting from the Configuration menu.
Image - Advanced
p.51
s
Adjust the Color Saturation and Tint settings from the Config-
uration menu.
Image - Color Saturation/Tint
s
64
Remedy
Remedy
Remedy
Signal - Aspect
p.52
s
Remedy
p.51
Advertisement
Table of Contents
