Adjusting The Sharpness - Epson EH-TW5750 User Manual

Adjusting the Image
a
Press the [Menu] button to display
menus in the order Signal - Aspect.
Remote control
c
You can only select Auto when the source is HDMI1 or HDMI2. This may not be available depending
on the type of input signal.
By normally selecting Auto, the optimum aspect is used to display the input signal. Change the setting if you
want to use a different aspect.
The table below shows the image projected on a 16:9 screen.
Aspect Mode
Normal
Full
Zoom

Adjusting the Sharpness

You can make the image clearer.
a
Press the [Menu] button to display
menus in the order Image -
Sharpness.
Remote control
The Sharpness adjustment screen is
displayed.
Control panel
Aspect Ratio for Input Signal
16:10
Control panel
33
b
Use the up and down buttons to select
the aspect mode, and then press the
[Enter] button to confirm the
selection.
16:9
b
Use the left and right buttons to make
adjustments.
The image is enhanced when moved to the
right (positive) and softer when moved to
the left (negative).
c
Press the [Menu] button to exit the
menu.
4:3