7. Reinstall the base cover assembly.
8. Turn over the computer. Connect the ac power adapter and all disconnected cables to the computer.
The short M.2 solid-state drive and its bracket
1. Disable the built-in battery. See "Disable the built-in battery" on page 35.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Remove the base cover assembly. See "Base cover assembly" on page 36.
5. Do one of the following to remove the M.2 solid-state and its bracket:
• Type one: Remove the screws that secure the M.2 solid-state drive bracket
bracket
2
. Then, remove the drive out of the slot
• Type two: Remove the screw that secures the M.2 solid-state drive bracket
bracket
2
. Then, remove the drive out of the slot
3
.
3
.
Chapter 6
1
, and remove the
1
, and remove the
.
41
CRU replacement