The long M.2 solid-state
1. Disable the built-in battery. See "Disable the built-in battery" on page 35.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Remove the base cover assembly. See "Base cover assembly" on page 36.
5. Remove the screw that secures the M.2 solid-state drive
6. Install a new M.2 solid-state drive:
a. Align the contact edge of the new M.2 solid-state drive with the key in the slot. Then, carefully insert
the drive into the slot at an angle of about 20 degrees
b. Pivot the M.2 solid-state drive downward
c. Install the screw to secure the M.2 solid-state drive
40
T14s Gen 1 and X13 Gen 1 User Guide
1
. Then, remove the drive out of the slot
1
.
2
.
3
.
2
.