Dell Precision 410 User Manual page 161

DIMMs
about, 8-5
capacities supported, 1-1
configuring, 8-5
installing, 8-6
removing, 8-7
sockets, 8-1
direct current
See DC
Diskette category, 3-9
Diskette Drive A and Diskette Drive B categories, 3-4
diskette drives
access indicator, 1-4
cleaning, D-3
connecting, 9-3
installing, 9-3
interface connector, 8-1
turning off built-in controller, 3-9
types, sizes, and capacities, 3-4
Display Power Management Signaling. See DPMS
DMI, 1-3
DPMS and power management, 3-7
drive bays
about, 9-1
installing drives, 9-3
drivers
audio, 6-3
bus-mastering EIDE, 2-4
NIC, 5-2
Drives
Primary and Secondary categories, 3-4
drives
See also diskette drives; EIDE hard-disk drives; SCSI
devices; tape drives
cables, 9-3
connecting to power, 9-3
formatting, 9-10, 9-15
front bezel, 9-1
front-panel inserts, 9-2
drives (continued)
installing, 9-3
location in chassis, 9-1
partitioning, 9-10, 9-15
termination, 9-10
types supported, A-3
drive-type numbers, 3-4
dual in-line memory modules. See DIMMs
E
ECC, 1-1, 8-5
EDO, 1-1, 8-5
EIDE drivers, bus-mastering, 1-3, 2-4
EIDE hard-disk drives
addressing, 9-6
disabling the built-in interface, 3-9
Drive 0 and Drive 1 categories, 3-4
formatting, 9-10
installing, 9-6
partitioning, 9-10
EIDE interface connectors, 8-1
electrostatic discharge. See ESD
enhanced integrated drive electronics. See EIDE
error checking and correction. See ECC
error messages, 3-14, C-1
ESD, vii, D-4
expansion cards
about, 8-2
configuring, 4-1
connectors, 8-3
installing, 8-3
removing, 8-4
resources, viewing, 4-9
with diskette drive controller, 3-9
with hard-disk drive controller, 3-9
with ports, 3-8, B-5
Index 3