Dell Dimension 8100 Solution Manual page 55
Dell dimension 8100: user guide
Hide thumbs
Also See for Dimension 8100:
- Service manual (130 pages) ,
- Solution manual (118 pages) ,
- User manual (158 pages)
Table of Contents
Advertisement
Slide the new drive/bracket assembly into the drive bay until both
7
drive bracket tabs snap securely into place.
NOTICE:
To avoid possible damage when you perform the following step, you
must match the colored strip on the interface cable with pin 1 on both the drive
and system board connectors.
Connect the interface cable for the drive.
8
If you are installing an EIDE device, make sure that the interface cable
is properly connected to the EIDE connector on the system board.
drive bracket assembly
drive bracket tab
Adding Pa rts
55
Hide quick links:
Advertisement
Table of Contents
