Removing Memory; Cards - Dell Dimension 4700 Series Owner's Manual

6
Close the computer cover.
NOTICE:
the computer.
7
Connect your computer and devices to electrical outlets, and turn them on.
8
Right-click the My Computer icon and click Properties.
9
Click the General tab.
10
To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Removing Memory

CAUTION:
located in the Product Information Guide.
NOTICE:
from your body before you touch any of your computer's electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
1
Follow the procedures in "Before You Begin" on page 47.
2
Press out the securing clip at each end of the memory module connector.
3
Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from
the connector.

Cards

CAUTION:
located in the Product Information Guide.
NOTICE:
from your body before you touch any of your computer's electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
60
Removing and Installing Parts
To connect a network cable, first plug the cable into the network wall jack and then plug it into
Before you begin any of the procedures in this section, follow the safety instructions
To prevent static damage to components inside your computer, discharge static electricity
Before you begin any of the procedures in this section, follow the safety instructions
To prevent static damage to components inside your computer, discharge static electricity