Installation Steps; Rack Mount Installation- Mid - Dell W-7205 Series Installation Manual

Installation Steps

To install a W-7205 controller from the front in a standard two-post 19-inch Telco rack:
1. Place the mounting brackets over the mounting holes near the front on either sides of the controller (see
7).
Figure 7
Attaching the Mounting Brackets
2. Secure the brackets to the controller using the eight screws for the mounting bracket (four per bracket) and a
suitable screwdriver.
3. If the rack requires cage nuts or clip nuts, insert them on the front rails (two per rail, aligned horizontally)
4. Mount the controller in the rack using the four screws for system rack mount (two per bracket) and a suitable
screwdriver (see
Figure 8
Front-Rack Mount Installation
NOTE: Leave a minimum of 10 cm (4 inches) of space on the left and right side of the controller for proper air flow and ventilation.
Leave additional space in the front and the back of the controller to access network cables, LED status indicators, and power cord.

Rack Mount Installation- Mid

An optional accessory kit (SPR-WL2-MNT, must be purchased separately) is available that allows mounting the W-
7205 controller from the middle in standard two-post 19-inch Telco rack.
CAUTION: Each W-7205 controller must have its own mounting equipment. Do not place other networking equipment directly on top
of a mounted W-7205 controller. Failure to do so can damage the controller.
Dell Networking W-7205 Controller | Installation Guide
Figure 8).
Figure
Installation | 23