Table of Contents
Advertisement
Table 6:
1000BASE-X Port LEDs
LED
STATUS
10GBASE-X Ports
The W-7205 controller is equipped with two 10GBASE-X (SFP+) ports (4 and 5). These ports are intended for use
with SFP/SFP+ and support dual-speed (1GbE or 10GbE) operation.
Figure 4
10GBASE-X Ports and LEDs
Each port is equipped two LEDs that allow basic monitoring of status, activity, and configuration of the port.
LINK/ACT— Placed to the top left of the port, this LED displays the link status and activity of the port.
l
STATUS— Placed to the top right of the port, this LED displays the status of the port. The information
l
displayed by this LED changes based on the LCD mode. The LED behavior corresponding to each LCD mode
is listed in
Table
Table 7:
10GBASE-X Port LEDs
LED
Function
LINK/ACT
Link status
Dell Networking W-7205 Controller | Installation Guide
Function
LCD Mode
Port status
Administrative
Duplex
Speed
7.
LCD Mode
NA
Indicator
Status
Green (Solid)
Port enabled
Off
Port administratively disabled
Green (Solid)
Full-duplex
Off
NA
Green (Solid)
1 Gbps
Off
NA
Indicator
Status
Green (Solid)
Link established
Green (Blinking)
Port is transmitting or receiving data
Off
No link
W-7205 Controller | 13
Advertisement
Table of Contents
