Servicing The Fuel Tank - Toro 30140 Operator's Manual

Always set the parking brake when you stop the machine or
leave it unattended. If the parking brake does not hold
securely, an adjustment is required.
Checking the Brakes
1. Park the machine on a level surface, disengage the
blade control (PTO) and set the parking brake.
2. Rear wheels must lock when you try to push the
machine forward or backward. Adjustment is required if
the wheels turn and do not lock; refer to Adjusting the
Brake, page 33.
3. Release the brake and press upper control bar very
lightly, approximately 1/2 inch (13 mm), wheels should
rotate freely.
4. If both conditions are met, no adjustment is required.
Adjusting the Brakes
The brake lever is on the upper control bar (Fig. 16). If the
parking brake does not hold securely, an adjustment is
required.
1. Check the brake before you adjust it; refer to Checking
the Brake, page 33.
2. Release the parking brake; refer to Releasing the
Parking Brake, page 19.
3. To adjust brake set the parking brake latch, and rotate
the wing nuts on the brake rods (Fig. 43). Clockwise to
tighten the brake and counterclockwise to loosen the
brake.
Note: Control bar should be parallel with reference bar
when properly adjusted.
4. Check the brake operation again; refer to Checking the
Brake, page 33.
Important With the parking brake released, the rear
wheels must rotate freely when you push the mower. If
brake action and free wheel rotation cannot be achieved
contact your service dealer immediately.
2
1. Brake rod

Servicing the Fuel Tank

Draining The Fuel Tank
Danger
In certain conditions, gasoline is extremely
flammable and highly explosive. A fire or
explosion from gasoline can burn you and others
and can damage property.
Drain gasoline from the fuel tank when the
engine is cold. Do this outdoors in an open area.
Wipe up any gasoline that spills.
Never smoke when draining gasoline, and stay
away from an open flame or where a spark may
ignite the gasoline fumes.
1. Park the machine on a level surface, to assure fuel tank
drains completely. Then disengage the blade control
(PTO) and set the parking brake.
2. Close the fuel shut–off valve in fuel line (Fig. 44).
3. Squeeze the ends of the hose clamp together and slide it
up the fuel line away from fuel filter (Fig. 44).
4. Pull the fuel line off the fuel filter (Fig. 44). Open fuel
shut-off valve and allow gasoline to drain into a gas can
or drain pan.
Note: Now is the best time to install a new fuel filter
because the fuel tank is empty. Refer to Replacing the Fuel
Filter; page 34.
5. Install the fuel line onto the fuel filter. Slide the hose
clamp close to the filter to secure the fuel line.
33
1
m–3773
Figure 43
2. Wing nut