Download Print this page
ADTRAN 1442120G1 Job Aid
ADTRAN 1442120G1 Job Aid

ADTRAN 1442120G1 Job Aid

Small form-factor pluggable gigabit ethernet, single-fiber 20 km

Advertisement

Quick Links

CLEI: VAUIAL8P _ _
Product P/N: 1442120G1
DESCRIPTION
The Small Form-Factor Pluggable (SFP) Gigabit Ethernet,
Single-Fiber is a bidirectional SFP that plugs into the
Central Office Optical Loop Termination (OLT) designed
to accept SFPs. The SFP provides a single optical
interface to the GigE physical interface. Installed into an
appropriate OLT, the SFP provides a Gigabit Ethernet
tributary interface to the supporting system.
NOTE: To ensure compatibility, refer to the documentation
provided with the OLT.
The following features are supported on the SFP:
1000Base-LX 1490 nm Transmitter
1000Base-LX 1310 nm Receiver
Optical distance: 20 km maximum
CAUTION: Due to compliance certification requirements,
only SFPs supplied by ADTRAN should be used.
ADTRAN cannot certify system integrity with
other SFPs.
Operational Specifications
Optical Specifications:
– Optical transmit level: –8 dBm to –3 dBm
– Optical receive level: –22 dBm to –3 dBm
– Optical budget: 14 dB
– Optical connectors: LC
Extended Environmental Support:
– Operational temperature range: –40°C to +85°C
– Storage temperature range: –40°C to +85°C
– Relative humidity to 95%, noncondensing
Small Form-Factor Pluggable
Gigabit Ethernet, Single-Fiber 20 km
INSTALLATION
To install the SFP into an appropriate module, complete
the following steps:
1. Inspect the SFP. If damaged, file a claim with the
carrier and then contact ADTRAN Customer Service.
2. Do not remove the protective end cap from the SFP
until the fiber optic cable is ready to be connected.
3. Insert the SFP into the SFP receptacle on the OLT.
Ensure the manufacturer's label on the SFP is facing
upward for correct installation.
4. Slide the SFP all the way into the receptacle until
there is an audible "click".
NOTE: The latch on the SFP is used to remove the SFP from
the cage on the circuit card.
5. Continue the installation and turn-up of the OLT
using the instructions in the Job Aid that
accompanied that OLT. The Installation and
Maintenance Practice (I&M) for the OLT is available
online at www.adtran.com.
Issue Date: 0802
Document P/N: 61442120G1-22A

Advertisement

loading

Summary of Contents for ADTRAN 1442120G1

  • Page 1 1000Base-LX 1490 nm Transmitter ♦ 1000Base-LX 1310 nm Receiver ♦ Optical distance: 20 km maximum CAUTION: Due to compliance certification requirements, only SFPs supplied by ADTRAN should be used. ADTRAN cannot certify system integrity with other SFPs. Operational Specifications ♦ Optical Specifications: –...
  • Page 2 SFP is properly grounded via the backplane connector. Warranty: ADTRAN will replace or repair this product within the warranty period if it does not meet its published specifications or fails while in service. Warranty information can be found online at www.adtran.com/warranty.