Honda DREAM YUGA Owner's Manual page 66

(6)
(5)
(3)
(4)
(2)
(1) Speedometer cable
(2) Tab ¼VS c ½
(3) Brake adjusting nut
(4) Front brake cable
(5) Brake arm ¼cz s d vkeZ ½
(6) Front axle nut ¼Ýa V ,Dly uV½
(7) Front axle shaft ¼Ýa V ,Dly "kk¶V½
58
(1) (7)
¼LihMks e hVj ds c y½
¼cz s d ,MtfLa V x uV½
¼Ýa V cz s d ds c y½
Installation Notes:
1. Reverse the removal procedure.
2. Position the wheel between the fork legs
and insert the front axle shaft from the
right side, through the right fork leg and
wheel hub.
Make sure that the tang (8) on the left
front fork leg is located in the slot (9) in the
brake panel.
3. Tighten the front axle nut to the
specified torque.
Front axle nut torque:
54 N·m (5.5 kgf·m , 40 lbf·ft)
Adjust the brake (page 14).
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not rotate
freely.
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Honda Motorcycle & Scooter India Pvt. Ltd.