Starting the programme
Touch and hold A Inicio/Pausa +
Carga (Start/Reload) button for 1~2
seconds, then release the button. The
programme starts and the appliance
door is locked.
The finish-in time is shown in the display
panel and counts down until the
programme starts. After the programme
has started, the programme duration is
displayed. And the symbols for the
programme progress are lighting up.
Childproof lock
You can lock the appliance to prevent
the settings you have set from being
changed inadvertently. To do this,
activate the childproof lock.
To activate the childproof lock:
After the programme starts, Touch and
hold the ( SpeedPerfect and ñ
Terminado en/em (Finish in/ Time Dry)
buttons for 3 seconds. The symbol E
lights up in the display panel.
E lights up: The childproof lock is
■
activated.
E flashes: If the programme and
■
programme settings are adjusted
while childproof lock is activated.
When the programme ends, "Ÿš
Note:
is displayed. The door is unlocked. E
symbol remain on to remind you to
deactivate the childproof lock.
To deactivate the childproof lock:
Touch and hold the ( SpeedPerfect
and ñ Terminado en/em (Finish in/
Time Dry) buttons until the symbol E
disappears.
Operating the appliance
Adding/removing laundry
After starting the programme (only for
washing), you can add or remove
laundry if necessary.
Touch the A Inicio/Pausa + Carga
(Start/Reload) button. The appliance
checks whether reloading is possible.
If the following appears on the display
panel:
The symbol Õ disappears,
■
reloading is possible.
The symbol Õ lights up, reloading is
■
not possible.
To continue the programme, touch the
A Inicio/Pausa + Carga (Start/Reload)
button. The programme continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the A Inicio/Pausa + Carga
1.
(Start/Reload) button.
Select another programme.
2.
And touch the A Inicio/Pausa +
3.
Carga (Start/Reload) button again.
The new programme starts from the
beginning.
If drying is activated, you can
Note:
change the programme by programme
selector directly.
en
39