Table of Contents
Advertisement
14.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme is set.
→ "Setting a programme", Page 34
¡ The programme settings have
been adjusted.
→ "Adjusting the programme set-
tings", Page 34
Press and hold 最愛 for approx. 3
▶
seconds.
Press 最愛 to call up the saved
programme.
Note: To overwrite the saved pro-
gramme, repeat the steps above.
14.5 Opening the door
Press on the edge of the door.
1.
Open the door.
2.
14.6 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 29
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 33
¡ The drum is empty.
Open the door.
1.
→ "Opening the door", Page 35
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
14.7 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or oxygen bleach, to
the manual dosing compartment. Do
not add any additional detergent to
the manual dosing compartment to
avoid overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 34.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 18
If required, add the care product.
3.
Push in the detergent drawer.
4.
14.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 34
Press
.
▶
Basic operation en
35
Advertisement
Table of Contents
