Appliance Settings; Sensors; Unbalanced Load Detection System - Bosch WNA13400ES Instruction Manual And Installation Instructions

Q

Appliance settings

Y ou can change the following settings:
A p p l i a n c e s e t t i n g s
The volume of the end signal.
■
The volume of the button signal.
■
Switching the drum care information
■
signal on/off.
You will need to activate the setting
mode in order to change these settings.
1/2/3/4... positions on the
programme selector
Activate setting mode:
Set the programme selector to
1.
position 1. The appliance is switched
on.
Touch and hold the 0 Centrif. (Spin
2.
Speed) button and, at the same
time, turn the programme selector
clockwise to position 2. Release the
0 Centrif. (Spin Speed) button.
The setting mode is activated and the
preset setting appears in the display
panel.
Changing the volume and drum care
information
Use the ñ Terminado en/em (Finish
in/ Time Dry) button to change the
following settings at the corresponding
programme selector positions:
2: The volume of the end signal.
■
Appliance settings
3: The volume of the button signals.
■
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
4: Switching the drum care
■
information signal on/off.
on
Ž
Πoff
Exiting setting mode
You can now end the process and set
the programme selector to the Û (Off)
position. The settings are saved.
H

Sensors

U nbalanced load detection
S e n s o r s
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the spin speed is reduced
or the spin cycle is not performed for
safety reasons.
Place large and small items of
Note:
laundry evenly in the drum.
en
41