Exmark Ultravac Bagger 126-8680 Operator's Manual page 14

Operation
6. Remove the belt cover on the right side of the
deck.
7. Mount the blower on the deck by inserting the
mounting pin into the tube welded to the rear
corner of the deck (see Figure 11). Pivot the
blower until the front pin engages the slot in
the deck. Adjust the position of the front pin
if necessary to engage the slot. Use the latches
to lock the blower in this position. Adjust the
tension on the latch to hold the blower up to the
deck, yet allow for release by hand.
1. Slot
2. Front pin
3. Blower latch
8. Pull the spring loaded idler back and slip the belt
over the top deck sheave.
View from Top of Blower
1. Impeller sheave
2. Deck sheave
9. Position the belt cover at an angle and slide it
under the mower frame (see Figure 13).
Figure 11
4. Mounting pin
5. Deck tube
Figure 12
3. Spring loaded idler
1. Blower
2. Belt cover
10. Push down on the back of the cover and slide it
g242047
backwards under the blower.
11. Slide the belt cover forward until it is seated under
both lips on the deck.
1. Blower
2. Belt cover
g009311
12. Install the knob and its hardware.
13. Slip the upper and the lower tubes together.
14. Insert the upper tube into the hopper seal –
push in then pull out so that the seal is extended
outward.
15. Align the dimple on the upper tube with the end
of hopper seal and center between the two screws
as shown in Figure 15.
14
Figure 13
3. Mower frame
Figure 14
3. Deck lip
g242180
g009341