Table of Contents
Advertisement
3
3.2.3
Sending data to your Mac computer (SMB Send)
Send scanned data to a computer on the network.
Once settings are configured, you can send data easily.
Preparation flow
The following describes a preparation flow for sending scanned data. For details, refer to the relevant page.
This preparation is not required the second time or subsequent times.
1
Checking the cable connection (Administrator)
% Check that this machine is correctly connected to the network cable. For details, refer to page 3-21.
2
Checking network settings of this machine (Administrator)
% Check the network settings of this machine. For details, refer to page 3-21.
3
Checking computer information
% Check the information required for Store Address, and fill out the checklist. For details, refer to
page 3-23.
4
Configuring your computer
% Configure settings to share a computer, or create a dedicated folder to receive files. For details, refer
to page 3-23.
5
Registering destinations
% Register destinations to which files are sent while checking the checklist. For details, refer to
page 3-23.
Operation flow
The following describes a transmission flow. For details, refer to page 3-26.
1
Load the Original
2
Selecting a destination
% Select a registered destination, and check the settings such as the file type and image quality.
3
Press the Start key.
% Press the Start key to scan the original.
3-20
Scan-to-Send function
bizhub 658e/558e/458e/368e/308e
3.2
Advertisement
Table of Contents
