Display And Operating Components; Display; Setting The Contrast; Fig. 6-1: Values For The Representation Type - Bosch Rexroth IndraControl VCP 25.2 Project Planning Manual

R911310386 / 02 | Rexroth IndraControl VCP 25.2

Display and Operating Components

6 Display and Operating Components
6.1

Display

6.1.1

Setting the Contrast

Electric Drives and Controls | Bosch Rexroth AG
Danger of intoxication!
If the display is damaged, avoid touching, swallowing or breathing in the
liquids or gases which may leak out.
Danger of corrosion!
If the display is damaged, avoid touching, swallowing or breathing in the
liquids or gases which may leak out.
The operator terminal is equipped with a STN display.
To define the contrast setting, use the programming software to set up
the system variable LcdContrast in any screen.
To do so, follow the instructions listed in the programming software's
help topic "How do I specify the contrast setting for the operating de-
vice".
In the programming software, enter the following values as lower and
upper limits for the representation type.
System Vari- Lower Limit
able
LcdContrast

Fig. 6-1: Values for the representation type

If you do not configure the system variable LcdContrast, the default
setting is used when the device is initialized.
If you did set-up the system variable, you can set the contrast as fol-
lows. Open the screen where you set up the system variable and:
1. Press the brightness button.
2. Enter a new value for the brightness. To do so, use the keyboard
shown on the screen.
3. Confirm with Enter.
The new contrast setting becomes effective immediately after the Enter
key is pressed. If necessary, repeat the steps two and three until you
are satisfied with the contrast.
Upper Limit
+ 1 + 31
6-1
Default Setting
+ 15