Table of Contents
Advertisement
ctrlX CORE
X3
plus
State
Service mode active
Identification
The ctrlX CORE Rescue system is active
Booting active or shut down
System error (F8 and F9
Runtime
① For the error codes, refer to:
⮫ https://docs.automation.boschrexroth.com/doc/2331677038/main-diagnostics/latest/en/
−
One square corresponds to a period of 200 ms.
−
The arrow represents the end of a cycle.
−
--: LED is not on.
−
BU: LED is blue.
−
GN: LED is green.
−
RD: LED is red.
−
WH: LED is white.
−
YE: LED is yellow.
A new status is only displayed after the previous flashing cycle has elapsed. A change in status
can thus be delayed up to two seconds.
12.2.2 Status display at the power connector XD10 ctrlX CORE
The voltages U
and U
L
P
respective red pusher.
Off = Voltage not present
On = Voltage present
12.2.3 Status display PF30-NET-ST-LED
The status display PF30-NET-ST-LED is a field bus diagnostic LED. For a detailed description, refer to
the documentation. See
12.2.4 Status displays PF56 to PF59-NET-ST-LED
The status displays PF56 to PF59-NET-ST-LED are field bus slave LEDs. For a detailed description, refer
to the documentation. See
12.2.5 Status display of device status LED
For the status displays of the device status LED of the infeed terminal, refer to the bus coupler
documentation, see
R911416731.
⮫
R911420136, Edition 01
Color
Flashing blue
Flashing white
Flashing red and
blue
Flashing blue
①
) in the ctrlX CORE
Red
applied at the connection points are signaled via an own green LED next to the
R911386579.
⮫
R911386579.
⮫
Status displays
--
--
--
BU BU BU BU BU
WH WH WH WH WH --
--
--
RD RD RD RD RD
BU BU BU BU BU
--
--
--
BU BU BU BU BU
RD
plus
Bosch Rexroth AG
33 / 46
--
--
--
--
--
--
Advertisement
Table of Contents
