Advertisement
T T o o r r e e m m o o t t e e s s t t a a r r t t t t h h e e v v e e h h i i c c l l e e : :
1.
Press the auxiliary channel on the transmitter twice within 3
seconds.
2.
The parking lights will flash to confirm remote start operation.
3.
Once the vehicle has started, it will run for the pre-program-
med period of time (12, 24, or 60 minutes) or until a shut-
down input is triggered. This can be set to minute increments
by your installer.
W W h h e e n n y y o o u u a a r r e e r r e e a a d d y y t t o o d d r r i i v v e e t t h h e e v v e e h h i i c c l l e e : :
1.
Insert the ignition key and turn it to the ON
(not the START) position.
2.
Press the brake pedal.
N N O O T T E E : : If the brake pedal is pressed before the key is in
the ON position, the engine will shut down.
While the vehicle is running during remote start operation, the sys-
tem will monitor the vehicle and will automatically shut down the
engine if the system receives any of the following shut-down inputs:
■
The brake pedal is pressed.
■
The hood is opened.
■
The shutdown toggle switch is put into the OFF position.
■
The pre-programmed run time has elapsed.
■
The auxiliary channel is pressed twice in 3 seconds.
T T o o s s h h u u t t d d o o w w n n t t h h e e r r e e m m o o t t e e s s t t a a r r t t a a n n d d t t u u r r n n o o f f f f t t h h e e e e n n g g i i n n e e : :
■
Step on the brake pedal, or
■
Press your auxiliary channel twice in 3 seconds.
6 6
2005 Directed Electronics—all rights reserved
©
Advertisement
