Disarming Without A Transmitter; Remote Controlled Chirp Muting - Directed Electronics Matrix 2 Owner's Manual

➜

disarming without a transmitter

This feature allows you to disarm the security system without the
remote transmitter should it be lost, damaged or disabled. In
order to disarm the system without a remote transmitter, you
must have the vehicle's ignition key and know where the Valet
switch is located. Be sure to check with the installer for the loca-
tion and the number of presses of the Valet switch required to
disarm the system.
To disarm the security system, turn
the ignition to the "on" position.
Press the Valet switch the preset
number of times (1-5 times) within 15 seconds. The system
should now disarm. If it does not, you may have waited too long;
turn the ignition off and on and try again.
important! The unit can be programmed to respond to 1-5
pulses of the Valet switch for the disarm function. Be sure
to check with the installer for the desired programming.
Location of Valet Switch_________________________________
➜

remote controlled chirp muting

To temporarily turn off the arm or disarm siren chirps, use
Remote Controlled Chirp Muting. Simply press
transmitter for less than one second before arming or disarming,
and the confirmation chirp(s) will be eliminated for that one op-
eration only. If you want the arm/disarm chirps turned off
permanently, your dealer can do this for you.
10
DRW-35
on the
© 2001 directed electronics, inc.