D-Link DWL-8200AP Manual page 64

DWL-8200AP User's Manual
Device Configuration > General (continued)
DHCP client:
Load Balance:
User Limit:
Console Protocol:
Telnet Timeout:
D-Link Systems, Inc.
There is a pull-down menu to select enabled or disabled. When
enabled, the selected device(s) will function as a DHCP client(s).
This allows them to receive IP configuration information from a DHCP
server. When disabled, the access point(s) must have a static IP
address assigned to them.
This pull-down selection enables or disables load balancing. When
you enable load balance you allow several access points to balance
wireless network traffic and wireless clients among the access points
with the same SSID. All the APs that share Load Balancing must
have the same SSID. Assign each access point a different
non-overlapping channel (e.g., 1, 6, 11).
Enter the number of the limit of load balancing users, from 0-64.
From the pull-down selection, choose either Telnet or SSH for
Console protocol.
This pull-down selection defines the timeout period during a Telnet
session with the selected device(s).
Status:
Select Enable to set the SNMP setting.
Using the AP Manager
64