Package Contents Note: Using a power supply with a different voltage than the one included with the DWL-8200AP will cause damage and void the warranty for this product. If any of the above items are missing, please contact your reseller.
Installing the Hardware Antennas Power Cord socket LAN 2 LAN 1 (PoE) Reset DWL-800AP Install Guide...
Page 4
Step 1 Connect one end of an Ethernet cable (included with your package) to the LAN 1 (PoE) port on the DWL-8200AP, and the other end of the Ethernet cable to the port labeled P+DATA OUT on the PoE base unit.
Page 5
Mounting Plate Assembly Step 1: Insert provided wall anchors in the wall where the mounting plate will be attached. Step 2: Use the provided screws to secure the mounting plate on the wall. DWL-800AP Install Guide...
Page 6
Step 3: Attach the remaining screws securely to the back of the DWL-8200AP. Step 4: Attach the DWL-8200AP to the mounting plate. DWL-800AP Install Guide...
Page 7
Step 5: Slide the DWL-8200AP down into the grooves on the mounting plate to secure it to the plate. DWL-800AP Install Guide...
Page 8
Your Setup is Complete When you have completed the steps in this Installation Guide and configured your for your network, your network should look similar to this: * Maximum Wireless signal rate derived from IEEE Standard 802.11a and 802.11g specifications. Actual data throughput will vary.
Page 9
Start your web browser program (Internet Explorer) and type the IP address of the DWL-8200AP in the address field (http://192.168.0.50) and press Enter. Make sure that the IP addresses of the DWL-8200AP and your computer are in the same subnet. DWL-8200AP also supports HTTPS Browsing by using the Secure Socket Layer (SSL) Protocol.
Page 10
• Type admin in the User Name field • Leave the Password field blank • Click OK Please refer to the manual for configuration help. DWL-800AP Install Guide...