D-Link AirPremier DWL-2200AP Manual page 35

802.11g wireless 108mbps access point with poe
Hide thumbs Also See for AirPremier DWL-2200AP:
Table of Contents

Advertisement

Using the AP Manager (continued)
Device Configuration>Wireless
• SSID: The Service Set (network)
Identifier of your wireless network.
• Channel: Allows you to select a
channel between 1-11.
• SSID Broadcast: Allows you to
enable or disable the broadcasting of
the SSID to network clients.
• 11g only: When enabled, only 802.11g
devices can connect to the selected
device(s).
• Super G: Super G is a group of
performance enhancement features
that increase end user application
throughput in an 802.11g network.
Super G is backwards compatible with
standard 802.11g devices. For ideal performance, all wireless devices on the network
should be Super G capable. The modes are listed below:
Super G Mode
Disabled
Super G without Turbo
Super G with Dynamic Turbo
Super G with Static Turbo
• Radio Wave: Enable or disable the wireless functionality of the selected device(s).
• Data Rate: A pulldown menu to select the maximum wireless signal rate for the
selected devices(s).
• Beacon Interval (20~1000): Beacons are packets sent by an access point to
synchronize a network. Specify the beacon value for the selected device(s) here. The
default value of 100 is recommended.
• DTIM (1~255): DTIM (Delivery Traffic Indication Message) is a countdown informing
clients of the next listening window for broadcast and multicast messages.
• Fragment Length (256~2346): This sets the fragmentation threshold (specified in
bytes). Packets exceeding the value set here will be fragmented. The default is 2346.
• RTS Length (256~2346): The RTS value should not be changed unless you encounter
inconsistent data flow. The default value is 2346.
• Tx Power: A pulldown menu for selecting the transmit power of the selected device(s).
Function
Standard 802.11g support. No enhanced
Capable of Packet Bursting, FastFrame
Capable of Packet Bursting, FastFrame
setting is backwards compatible with no
only enabled when all devices on the wir
Dynamic Turbo enabled.
Capable of Packet Bursting, FastFrame
setting is not backwards compatible with
always on and is only enabled when all d
with Super G and Static Turbo enabled.
35

Advertisement

Table of Contents
loading

Table of Contents