Placing The Speakers - Yamaha NS-M325 Owner's Manual

Place the speakers on a sturdy, vibration-free surface, on a
well-built stand.
■ Using as 2ch stereo speakers
Better stereo images will be obtained when the speakers
are slightly angled in towards the listeners.
■ Using as front speakers in a multi channel
system
Position the speakers on both sides of the TV. The
positioning of speakers is important, because it controls the
whole sound quality of a multi channel system. Set up the
speakers on the basis of your listening position by following
the owner's manual supplied with your amplifier.
■ Using as presence or surround speakers
Mount the speakers on a wall or place the speakers on a
shelf. Determine the best position by following the owner's
manual supplied with your amplifier.
NS-M325
(Presence)
NS-M325
(Front)
Note:
This speaker features a magnetically shielded design,
but there is still a chance that placing it too close to a
TV set might impair picture color or create a buzzing
noise. Should this happen, move the speaker away from
the TV set.
2
E-

PLACING THE SPEAKERS

Subwoofer
NS-M325
(Surround
Center
back)
NS-M325
(Surround)
■ To mount the speaker on a wall by using
the attached mounting bracket
Fasten screws into a firm wall or wall support as shown
in the figure, and hang the holes of the mounting
bracket on the protruding screws.
* Make sure that the screws are securely caught by the
narrow parts of the holes.
Wall/ wall
support
You can also use the screw holes on the rear of the
speaker for installing the speaker using a commericially
available speaker bracket (if you do not use the attached
mounting bracket).
WARNING:
• This speaker weighs 3.8 kg (8.4 lbs). Do not mount it
on thin plywood or a wall with soft surface material. If
mounted, the screws may come out of the flimsy
surface and the speaker may fall. This damages the
speaker or causes personal injury.
• Do not install the speaker to a wall with nails,
adhesives, or any other unstable hardware. Long-
term use and vibrations may cause it to fall.
• To avoid accidents resulting from tripping over loose
speaker cable, fix it to the wall.
Tapping screw (3.5–4 mm)
(Available at the hardware
store)
Min.
20 mm
3 mm
40 mm
Screw holes
Diameter: 6 mm
Hole depth: 15 mm
60 mm