Placing The Speakers - Yamaha NS-M525 Owner's Manual

Place the speakers on a sturdy, vibration-free surface, on a
well-built stand.
■ Using as 2ch stereo speakers
Better stereo images will be obtained when the speakers
are slightly angled in towards the listeners.
■ Using as front speakers in a multi channel
system
Position the speakers on both sides of the TV. The
positioning of speakers is important, because it controls the
whole sound quality of a multi channel system. Set up the
speakers on the basis of your listening position by following
the owner's manual supplied with your amplifier.
■ Using as presence or surround speakers
Mount the speakers on a wall or place the speakers on a
shelf. Determine the best position by following the owner's
manual supplied with your amplifier.
NS-M525
Presence
Center
NS-M525
Front
Note:
This speaker features a magnetically shielded design,
but there is still a chance that placing it too close to a
TV set might impair picture color or create a buzzing
noise. Should this happen, move the speaker away from
the TV set.
2
E-

PLACING THE SPEAKERS

Subwoofer
NS-M525
Surround back
NS-M525
Surround
■ To mount the speaker on a wall by using
the attached mounting bracket
Fasten screws into a firm wall or wall support as shown
in the figure, and hang the holes of the mounting
bracket on the protruding screws. By setting the two
supplied bass control plugs into the ports on the rear of
the speaker, the tone and volume balance of the low
bass sound produced between the port and the wall will
be better.
* Make sure that the screws are securely caught by the
narrow parts of the holes.
Wall/ wall
support
You can also use the screw holes on the rear of the
speaker for installing the speaker using a commericially
available speaker bracket (if you do not use the attached
mounting bracket).
WARNING:
• This speaker weighs 4.5 kg (9 lbs.14.7 oz.). Do not
mount it on thin plywood or a wall with soft surface
material. If mounted, the screws may come out of the
flimsy surface and the speaker may fall. This
damages the speaker or causes personal injury.
• Do not install the speaker to a wall with nails,
adhesives, or any other unstable hardware. Long-
term use and vibrations may cause it to fall.
• To avoid accidents resulting from tripping over loose
speaker cable, fix it to the wall.
Tapping screw (3.5–4 mm)
(Available at the hardware
store)
Min.
20 mm
3 mm
40 mm
Screw holes
Diameter: 6 mm
Hole depth: 15 mm
60 mm