Supplied Accessories; Connections To Your Amplifier; Placing The Speakers - Yamaha NS-C700 Owner's Manual

SUPPLIED
ACCESSORIES
Fastener × 4

PLACING THE SPEAKERS

Place the speaker on a TV rack or other stable surface. To prevent
the speaker from falling down, attach the fasteners provided in
each corner of the speaker's underside.
Front
NS-C700
Fastener
Notes
• Do not touch the adhesive surface after peeling off the seal
as this will weaken its adhesive strength.
• Thoroughly wipe clean the surface where the fasteners are
to be attached. Note that adhesive strength is weakened if
the surface is dirty, oily or wet, and that this may cause the
center speaker to drop.
• Placing this unit too close to a TV set might impair picture
color or create a buzzing noise. Should be happen, move the
speaker away (more than 20 cm (7-7/8")) from the TV set.
• To avoid accidents resulting from tripping over loose
speaker cables, fix them to the floor.
Before making connections, make sure that the amplifier is
switched off.
Subwoofer
Surround
back
Surround
• Connect the screw-type input terminals at the rear of the
• Connect the (+) terminals on the amplifier (or receiver) to the
• Connect the speaker to the center terminals of your amplifier,
CONNECTIONS TO YOUR
AMPLIFIER
Loosen
Black (–)
Insulation
coating
CENTER
Amplifier or
Receiver
speakers to the speaker output terminals of the amplifier (or
receiver) with the speaker cable.
(+) terminal of each speaker, making sure to confirm the color-
coded wire of the cable at each end. Use the other wire of the
cable to connect the (–) terminals of the components.
making sure not to reverse the polarity (+, –). If the speaker is
connected with reversed polarity, the sound will be unnatural
and lack bass.
Tighten
Red (+)
Bare wire
NS-C700
+
–
1
En