Table of Contents
Advertisement
To set/clear the display of the base unit
number on a handset
The factory setting is to display the number.
This is useful if your handset is connected to
more than one base unit.
7
PQRS
STO
Press the
button.
•
STO
Press the
button then the
•
3
The current setting is displayed.
Press the
button to display the base unit
•
1
number.
or
Press the
button if you do not want to
•
0
display the base unit number.
Press the
button to confirm.
•
STO
6
MNO
button.
6
To set your handset for automatic base
selection
If you are moving around, and likely to lose
contact with your base unit, your handset can
be made to automatically switch to the first
available base unit. If this is set and you are in
the area where the signals of two base units
are overlapping, your handset will select the
strongest signal.
The handset must be switched
STO
INT
Press the
button.
•
STO
Press the
button. Display shows the
•
INT
numbers of the base stations at which the
handset is registered.
Press the
button to set automatic selection.
•
0
Press the
button to confirm. The
•
STO
handset will now select the base unit offering
the strongest signal. Display will show the
base unit selected (unless de-activated – see
previous paragragh to set/clear the display
of the base unit number on a handset).
Operating with additional
ON
0
base unit
48
Advertisement
Table of Contents
