Husqvarna T540XP II Operator's Manual page 21

Hide thumbs Also See for T540XP II:
Table of Contents

Advertisement

Available languages

Available languages

7. Pull the starter rope until 1 cm of the spring guide is
shown. At the same time, press down the starter
handle cover and remove it from the starter rope
handle.
Note: If the starter rope is broken in the starter rope
handle, push the starter handle cover down. Use the
combination wrench to remove the starter handle
cover.
8. Attach a new starter rope to the pulley. Wind the
starter rope approximately 3 turns around the pulley.
9. Connect the pulley to the recoil spring. The end of
the recoil spring must engage in the pulley.
10. Attach the screw to the center of the pulley.
11. Pull the starter rope through the hole in the starter
housing, the starter rope handle and the spring
guide.
12. Make a knot 1 cm/0.5 in (A) from the end of the
starter rope.
13. Put the rope end or the starter rope parallel to the
knot.
524 - 003 -
1 cm/0.5 in
14. Push down the knot into position in the spring guide
(B).
1 cm/0.5 in
A
15. Pull the starter rope until 1 cm of the spring guide is
shown. At the same time, assemble the starter
handle cover.
To tighten the recoil spring
1. Put the starter rope into the notch in the pulley.
2. Turn the starter pulley approximately 2 turns
clockwise.
3. Make sure that you can turn the pulley ½ turn after
the starter rope is fully extended.
To assemble the starter housing on
the product
1. Pull out the starter rope and put the starter in
position against the crankcase.
2. Slowly release the starter rope until the pulley
engages with the pawls.
B
1 cm/0.5 in
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

967 28 76-14967 28 76-16970 48 40-14

Table of Contents