Husqvarna T540XP II Operator's Manual page 20

2. Push the start/stop switch to the STOP position. The
engine must stop.
To do a check of the muffler
1. Make sure that the muffler is not defective.
WARNING: Do not use a product that
has a defective muffler or a muffler that
is in bad condition.
2. Make sure that the muffler is correctly attached to
the product.
™
AutoTune
Your product has the AutoTune
the carburetor automatically, which gives the best
possible adjustment. AutoTune
to weather conditions, altitude, gasoline and the type of
two-stroke oil.
CAUTION: If AutoTune
correctly, speak to your servicing dealer.
The product adjusts correctly after some
fuelings.
To replace a broken or worn starter
rope
1. Loosen the screws to the starter housing.
20
™
function that adjusts
™
lets the engine adapt
™
does not work
2. Remove the starter housing.
3. Pull out the starter rope approximately 30 cm/12 in
and put it in the notch on the pulley.
4. Let the pulley rotate slowly rearward to release the
recoil spring.
5. Remove the bolt in the center of the pulley and
remove the pulley.
6. Hold the starter rope handle.
524 - 003 -