Table of Contents
Advertisement
87076_1.book Page 11 Monday, March 10, 2008 9:21 AM
Chapter 2: Installing the system
Connection overview
The Course Computer provides the following system connections
Fluxgate
compass inputs
2.4 Mounting the SportDrive
The SportDrive fits over your boat's existing steering shaft, and the steering wheel is
secured to the SportDrive.A taper adaptor is provided to enable the SportDrive to be
fitted to either
components are fitted depends on the diameter of the steering shaft, you need to
ascertain the diameter of the steering shaft before you fit the SportDrive.
Step 1 – Remove the steering wheel
CAUTION: Turn the wheel fully clockwise
Before you remove the steering wheel, it is very important to turn it fully
clockwise, otherwise damage to the Sport Pilot drive could occur, in the
later stages of installation,
1. Turn the wheel fully clockwise to starboard lock.
2. Remove the steering wheel hub cover.
3. Holding the steering wheel at full starboard lock, use the supplied box spanner or
a suitable socket to remove and retain the wheel securing nut and washer.
4. Carefully remove the steering wheel (a bearing puller will assist with this).
5. Remove and retain the woodruff key.
SeaTalk fuse
(2 A)
2
NMEA 0183
input/ouput
Rudder position
SeaTalk
sensor inputs
inputs/outputs
/
in (19 mm) or 1 in (25 mm) steering shaft tapers. As the way in which
3
4
Power fuse
(15A)
15
A
B
ng
SeaTalk
Power
inputs/outputs
inputs
(12 V)
Drive motor
outputs
11
Note: Spare fuses
are located in the
connector cover
RF ground
connection
D10374-1
Advertisement
Table of Contents
