4. To install the pop-up camera assembly:
a) Route the camera cable through to the routing channel [1].
b) Align and place the pop-up camera assembly on the display panel base [2].
c) Replace the two screws (M3x5) that secure the pop-up camera assembly to the middle frame [3].
5. To replace the camera assembly cover:
a) Connect the camera cable to the system board [1].
b) Align and place the pop-up camera assembly cover on the middle frame [2].
c) Replace the two screws (M3x5) that secure the camera assembly cover to the middle frame [3].
48
Removing and Installing components