Installing The Bottom Grids; Care And Cleaning - Westinghouse QK044 Owner's Manual

Installation (continued)

INSTALLING THE BOTTOM GRIDS

- Ensure that the vanishing edge
sinks (A) before placing the bottom grids (B) .
- The bottom grids (B) must be positioned with the rubber supports down .
Tilt the grids up so it is at a slight angle, slide them into the sink (A), and
place them so that they are sitting flat on the bottom of the sink.

Care and Cleaning

Your sink is manufactured with the highest grade stainless steel and will provide you many years of enjoyment with proper care .
Do
- After use, always rinse your sink with tap water to dilute and
remove deposits .
- Towel dry the sink after use whenever possible to prevent
water spots . Should water spots occur, clean with a mild
solution of vinegar and water followed by a thorough rinse .
- Use liquid soap, a general household cleaner, or a weak
solution of vinegar and water for regular cleaning .
- Only use plastic scouring pads recommended for use in
stainless steel sinks, and only use them in the bowl of the
sink . Scrub in the direction of the grain (original polish lines) .
SCRATCH, SPOT, AND BLEMISH REMOVAL AND SURFACE RESTORATION:
Little rust spots and blemishes that periodically appear in the sink are typically the result of the steel interacting with the chemicals
found in the vast spectrum of substances that sinks are commonly exposed to . They may also get transferred from other objects
placed or left in the sink . Scratches are the result of regular wear and tear .
To remove scratches, spots, and blemishes from the sink, rub them with a non-metallic scouring pad (e .g . Scotch-Brite
with a mild abrasive cleaner (e .g . Vim
finished, rinse the sink with water and dry it with a towel to allow the sink to form a protective outer layer. This procedure can also be
used to renew all of the surfaces of the sink .
QK044
TM
strainer baskets (C) are already in the
® or Barkeeper's Friend ® ) . Always rub the surfaces in the direction of the grain of the steel . When
A
Do Not
- Do not allow any food, detergent, soap or grease to dry or sit
for extended periods of time on the surface of the sink .
- Never use abrasive cleaning products, as they will dull and
scratch the finish.
- Do not use scouring pads on the deck, as they will dull the
mirror finish.
- Never use steel wool pads, as they will leave iron particles
on the sink, which will cause corrosion .
- Never leave steel or cast iron pans in your sink for extended
periods of time, as this can cause corrosion .
- Never use chlorine-based cleaners in your new sink, they
could lead to rust spots and discolouration . If you must use
them, rinse sink thoroughly with fresh water immediately
after use . If any chemicals or glue make contact with the
sink during installation, wipe clean and rinse thoroughly
with fresh water .
12
C
B
® ) combined