Browser; Security; Pin Protect; Protecting The Radio With A Pin Code - Motorola MTP3250 Feature User Manual

3 Highlight your firearm sensor device and press Connect.
NOTICE:
Activation code must be sent to the device by third-party application.
Radio-initiated automatic reconnection with several remote Bluetooth devices at the
same time cannot be guaranteed to be successful in 100%, due to the fundamental
nature of Bluetooth. In case the reconnection fails after a power cycle (power off and
power on of the radio), reconnect the device manually.
The radio is now able to notify the dispatcher when the status of the firearm device changes. If
configured, the location (using GNSS) of the radio is reported as well. Once a firearm sensor
device is connected, it can be managed from the Devices menu.
4 To disconnect a firearm sensor device, go to the Devices menu and follow the normal device
management procedure.
4.6

Browser

This menu item activates a WAP browser that allows you to browse the Internet from your radio. See
Wireless Application Protocol (WAP) on page
4.7

Security

Security menu stores all your security settings.
4.7.1

PIN Protect

This feature allows you to enable/disable PIN code authentication at the next power on. This code
protects your radio against unauthorized use.
NOTICE: Customers are strongly advised to change the default PIN code in order to protect
devices from unauthorized access.
If you are unable to unlock the radio, you can only send or receive Emergency Calls and adjust the
volume level with the Volume Knob.
NOTICE: If the radio uses a BSI PIN code and you are unable to unlock the radio, you cannot
take any action.
4.7.1.1

Protecting the Radio with a PIN Code

Procedure:
1 From the home screen, press the Menu key.
2 Select Security→PIN Protect.
3 Select On.
4 Enter the PIN code.
NOTICE: To increase security, set your own PIN code. By default the PIN code are all
zeros (depending on the length of the PIN code). For radios with general PIN
authentication, the PIN length is a fixed 4-digit code. For radios with BSI PIN
authentication, the PIN length is configurable by your service provider up to a maximum
of 8-digit code.
140.
68015000899-FH
Chapter 4: Main Menu
87