TP-Link TL-WR940N User Manual page 23

Chapter 4
• Connect Automatically
when it is down.
• Time-based Connecting
from the start time to the end time (both are in HH:MM format).
• Connect Manually
immediately. This mode also supports the
on Demand mode. The Internet connection can be disconnected automatically
after a specified inactivity period (Max Idle Time) and not be able to re-establish
when you attempt to access the Internet again.
Note:
• Only when you have configured the system time on the
connecting function take effect.
• Sometimes the connection cannot be terminated although you have specified the
applications are visiting the Internet continually in the background.
If you want to do some advanced configurations, please click Advanced.
• MTU Size - The default MTU size is 1480 bytes. It is not recommended that you change
the default MTU size unless required by your ISP.
• Service Name/AC Name
should not be configured unless you are sure it is necessary for your ISP. In most cases,
leaving these fields blank will work.
• ISP Specified IP Address
router, please select
by your ISP in dotted-decimal notation.
• Detect Online Interval
interval. The default value is 0. You can input the value between 0 and 120. The value
0 means no detect.
• Primary DNS/Secondary DNS
to the router, please select
- The connection can be re-established automatically
- The connection will only be established in the period
- You can click Connect/Disconnect
- The service name and AC (Access Concentrator) name
- If your ISP does not automatically assign IP addresses to the
Use IP address specified by ISP
- The router will detect Access Concentrator online at every
- If your ISP does not automatically assign DNS addresses
Use the following DNS servers
to connect/disconnect
Max Idle Time
System Tools > Time Settings
Max Idle Time
and enter the IP address provided
and enter the IP address in
Configure
function as Connect
page, will the time-based
because some
21