ADTRAN 1203019L2 User Manual page 23

powered from the NT1, verify that the total power require-
ment of the connected TE is less than 8.9 watts.
To connect the NT1 ACE to the NT1 Power Supply, perform
the following steps as illustrated in Figure 4.
1. Connect the Power Supply to the NT1 ACE at the
POWER jack located on the NT1 ACE.
2. Plug the Power Supply into the nearest wall outlet
supplying 110 VAC, 60 HZ.
3. On the NT1 ACE, verify that the POWER and ERROR
indicators are illuminated. After approximately 15
seconds, the READY indicator should flash at a 1 Hz
rate. Should any of the indicators fail to operate as
stated, see the section Troubleshooting on page 11.
61203019L1-1
1 0 0 - 1 2 0
Figure 4. Power Supply Connection
NT1 ACE User Manual
NT1 ACE User Manual
POWER NETWORK
VA C
LOCAL
7