Table of Contents
Advertisement
Answering System
Number of rings before the unit
answers a call
You can change the number of times the
phone rings "Ring count" before the unit
answers calls. You can select 2 to 7 rings, or
"Toll saver".
The default setting is "4 rings".
"Toll saver": The unit's answering system
answers at the end of the 2nd ring when new
messages have been recorded, or at the end
of the 5th ring when there are no new
messages. If you call your phone from outside
to listen to new messages (page 39), you
know that there are no new messages when
the phone rings for the 3rd time. You can then
hang up without being charged for the call.
1
MMenuN (right soft key) #211
2
MbN: Select the desired setting. a
MSaveN a MOFFN
For Voice Mail service subscribers
If you subscribe to a flat-rate service package
that includes Call Display, Call Waiting, Voice
Mail, and unlimited local/regional/long
distance calls, please note the following:
R To use the Voice Mail service provided by
your service provider/telephone company
rather than the unit's answering system,
turn off the answering system (page 35).
R To use this unit's answering system rather
than the Voice Mail service provided by
your service provider/telephone company,
please contact your service provider/
telephone company to deactivate your
Voice Mail service.
If your service provider/telephone company
cannot do this:
– Set this unit's "Ring count" setting so
that this unit's answering system
answers calls before the Voice Mail
service of your service provider/
telephone company does. It is necessary
to check the number of rings required to
activate the Voice Mail service provided
by your service provider/telephone
company before changing this setting.
– Change the number of rings of the Voice
Mail service so that the answering
40
PRS120C(en)_0121_ver110.pdf
Caller's recording time
You can change the maximum message
recording time allowed for each caller. The
default setting is "3 min".
1
2
Selecting "Greeting only"
You can select "Greeting only" which sets
the unit to announce a greeting message to
callers but not record messages.
Select "Greeting only" in step 2 on
"Caller's recording time", page 40.
Note:
R When you select "Greeting only":
40
system can answer the call first. To do
so, contact your service provider/
telephone company.
MMenuN (right soft key) #305
MbN: Select the desired setting. a
MSaveN a MOFFN
– If you do not record your own message,
the unit will play the pre-recorded
greeting-only message asking callers to
call again later.
– If you use your own message, record the
greeting-only message asking callers to
call again later (page 35).
2014/01/29
14:56:59
Advertisement
Table of Contents
