Record Mode - Oregon Scientific MP303 User Manual

To tune a channel:
1. In the "Radio" mode, press the
2. Then use the
NOTE: FM scanning reception may vary in different areas.
To exit the Radio mode:
Simply press the
Menu).
The display in the Radio mode, you will see:
1. Button hold indicator
2. Battery status indicator
3. Frequency display (e.g. 102.35MHz)
4. Information display

RECORD MODE

Prior to initiating Voice Recording, the user must verify the record option
in the Settings Menu.
To verify the record settings:
1. From the Main Menu, select the "Settings" Menu option.
2. Using the
3. For the "Source" option, press the
4. After selecting "Microphone" as the source, use the
MP303 Eng r10 OP
in the "Tune" mode. (If the screen says "Preset" then you will
need to press the key twice).
button to move up or down. (The FM band number
will increase or decrease as you move the key. Simply tune until
you find a clear channel you want to listen to).
or MENU / ON button. (You will return to the Main
button, scroll down until you highlight the "Record
Settings" sub-menu option. Press the
to display this menu.
switch between the various recording sources. (The default
setting is "Microphone," which is used for voice recording. Another
option is "FM" for recording from the FM radio).
down to the data rate. (The recommended data rate for voice
recording is 8000HZ, as this creates acceptable quality and
small files sizes).
16
/ OFF button to set the screen
or MENU / ON button
or MENU / ON button to
16
to scroll
9/16/04, 5:47 AM