Table of Contents
Advertisement
Caution
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even for a few minutes.
Adjusting the Height-of-Cut
The height-of-cut adjusts from 1-1/2 to 4-1/2 inches (38 to
114 mm) in 1/4 inch (6 mm) increments by relocating the
clevis pin in different hole locations.
1. Raise the height-of-cut lever to the transport position
(also the 4-1/2 inch [114 mm] cutting height position)
(Fig. 17).
Figure 17
1. Height-of-cut lever
2. Remove the clevis pin from the height-of-cut bracket
(Fig. 17).
3. Select the hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and insert
the clevis pin (Fig. 17).
4. Lower the height-of-cut lever onto the clevis pin
(Fig. 17).
1
2
m–4122
2. Clevis pin
21
Adjusting the Anti-scalp
Rollers
Whenever you change the height-of-cut, adjust the height
of the anti-scalp rollers.
Adjusting the Outer Roller
1. Disengage the PTO, move the motion control levers to
the neutral locked position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting the height-of-cut, remove the nut and
washer while holding the stud with a wrench (Fig. 18).
4
3
2
Figure 18
1. Outer roller
2. Stud
3. Washer
Note: Do not remove the wheel nut and washer
(Fig. 18).
4. Select a hole so that the outer roller is positioned to the
nearest corresponding height-of-cut desired (Fig. 18).
5. Install the stud nut and washer (Fig. 18).
6. Repeat the adjustment on the other rollers.
1
5
m–4167
4. Nut
5. Wheel nut and washer.
Do not remove.
Advertisement
Table of Contents
