Troubleshooting - Zanussi ZDN11002XA User Manual

CLEANING THE SPRAY ARMS
Do not remove the spray arms. If the holes in the
spray arms are clogged, remove remaining parts of
soil with a thin pointed object.
EXTERNAL CLEANING
• Clean the appliance with a moist soft cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive cleaning
pads or solvents.

TROUBLESHOOTING

If the appliance does not start or it stops during
operation, before you contact the Service, check if
you can solve the problem by yourself with the help
of the information in the table.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with wa-
ter.
• The indicator
intermittently.
• The indicator
ously.
The appliance does not drain the
water.
• The indicator
times intermittently.
• The indicator
ously.
The anti-flood device is on.
• The indicator
times intermittently.
• The indicator
ously.
•
•
•
•
•
•
•
•
flashes 1 time
•
•
flashes continu-
•
•
•
flashes 2
flashes continu-
•
flashes 3
flashes continu-
INTERNAL CLEANING
• Carefully clean the appliance, including the
rubber gasket of the door, with a soft moist
cloth.
• If you regularly use short duration programmes,
these can leave deposits of grease and
limescale inside the appliance. To prevent this,
we recommend to run long duration
programmes at least 2 times per month.
With some problems different indicators flash
intermittently and/or continuously to show an alarm
code.
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that there is no a damage fuse in the fuse box.
Make sure that the appliance door is closed.
Press Start.
If the delay start is set, cancel the setting or wait for the
end of the countdown.
The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the proce-
dure is approximately 5 minutes.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
13